german helmet decal SS, 1rst pattern...
german helmet decal SS, 1rst pattern (early) 'EF'
ultra high quality reproduction, background foil silver + white metal high effect, glue 'perfect replica' supplied.
Warning: Last items in stock!
By buying this product you can collect up to 2 loyalty points. Your cart will total 2 loyalty points that can be converted into a voucher of 0,40 €.
EARLY SS DECAL + GLUE ’PERFECT REPLICA’ (natural resin)
This decal is premium quality . Particular care has been taken during its manufacture. Our concern is to always approach the same quality of true German insignia of the time. If you used to see and examine reals SS decals, you’ll be surprised at the quality of reproduction!
This series is designed specifically for those who make use artificial aging and decals. After aging , the result is astonishing , even under a loupe . After 5 years of research and testing , never such a quality of reproduction had been reached.
the bottom is made with a very shiny silver coating + a layer of white metallic typical SS decals.
glue is free for the purchase of premium decal. if you order several decals you will receive 1 bottle containing the necessary dose of glue.
We also managed to remake the same one of the three glues that the Germans used in their plants for the installation of decals on helmets. This new adhesive ( natural resin ) ’perfect replica is offered with decals PREMIUM.
The sizes, colors and design features are fully respected. The base metal badges feature many HEER is perfectly reproduced .
====== instructions for apply decal =======
This adhesive resin 'perfect replica' is exactly the same glue that was used for apply decals in factories of German helmets.
Materials needed: a small brush, water, a wet sponge, cloth and turpentine.
CAUTION do not confuse gasoline with turpentine and turpentine.
You need pure turpentine.
If you then want your old your decals, know that this is long glue to harden under the decal . Wait 7 to 10 days before the start aging, it's better.
You apply a thin layer of adhesive resin, do not be afraid to extend well beyond the dimensions of the decal.
At the same time , you also put glue resin on any item, here a lid. It will serve as a witness to see when the glue becomes very sticky.
You also put the decal twenty seconds in water and then you put it flat.
We must apply the decal at the right time. The glue is a natural resin diluted with turpentine. When turpentine evaporates, the resin will become sticky.
The resin is sticky when put a little stronger finger. so you have to wait while evaporating the turpentine will make the resin more sticky, we see it if we put the finger without pressing.
Then the resin will become less sticky if the finger is placed, but she will remain tacky if the finger seconded above. it is at this point that we must place the decal.
With the help of the paper decal, plate the decal chasing any air bubbles and water.
You should get this result. The hardest part is done! You notice the excess glue around the decal. This is quite normal. For the moment we let the glue dry, we will remove it without problem in a few hours.
After a few minutes, the glue is dried around, so we will remove it.
just pass a brush soaked in turpentine to dissolve the glue .
Then you place a wet sponge to clean.
A slight rub. Do not press too because do not forget the glue under the badge is still soft .
the final result: a perfectly applied decal, well bonded to the helmet and without any trace of glue.